[. . . ] capacity washer) or 1½" (38 mm) (to match height of 3. 8 cu. [. . . ] floor moldings.
18"* (457 mm)
48 in. 2* 2 (310 cm )
■■ Additional clearances might be required for wall, door, and ■■ Additional spacing of 1" (25 mm) on all sides of the dryer 24 in. 2 * 2 (155 cm ) 1" (25 mm) 29" (737 mm) A 1"* 27¾" 1" (25 mm) (25 mm) (705 mm) B 3"* (76 mm)
is recommended to reduce noise transfer.
■■ For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
C
■■ Companion appliance spacing should also be considered.
A. Closet door with vents
*Additional spacing recommended
W10562358A 03/2014
ELECTRICAL REQUIREMENTS
To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz. , AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. ■■ When using elbows or making turns, allow as much room
as possible.
■■ Bend vent gradually to avoid kinking. ■■ Use as few 90° turns as possible.
Determine vent length and elbows needed for best drying performance:
■■ Use following Vent System Chart to determine type of vent
material and hood combinations acceptable to use.
NOTE: Do not use vent runs longer than those specified in Vent System Chart. Exhaust systems longer than those specified will:
■■ Shorten life of dryer. [. . . ] ■■ Reduce performance, resulting in longer drying times
and increased energy usage.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. [. . . ]